Technical Characteristics - Ecler ATA1-1 Manual De Instrucciones

HOW TO USE IT
Put the "SELECTOR" switch on the "TEL SET" position and make the telephone call to the
listener. This signal will not be present at the output of the ATA1-1.
Switch to "STANDBY" to retain the call and hang the telephone set. The listener will hear
the program but his/her voice will not be at the output of the adapter.
To broadcast the listener voice, switch to "ON AIR" and adjust the input level of the
telephone line to the audio mixer by means of the "OUTPUT LEVEL" of the adapter.
The adaptation of the ATA1-1 to the telephonic line is made through the "ADJ" control.
Switch from STAND BY to ON AIR and move the ADJ control until the minimum tonal difference
between the incoming call and the adapter's output signal is reached with the OUTPUT LEVEL as
high as possible.

TECHNICAL CHARACTERISTICS

Inputs
Outputs
Dimensions
Weight
¼" mono jack for the telephone line.
RCA sockets for the stereo channels of the audio mixer.
Telephone line impedance
Mixer
¼" mono jack for the telephone line.
RCA sockets for the stereo channels of the audio mixer.
Telephone line impedance
Mixer
Front panel
Chassis
600Ω
-15dBV(180mV)/47KΩ
600Ω
-15dBV(180mV)/47KΩ
241mm x 44mm x 2mm
200mm x 42mm x 122mm
1Kg
5