Publicidad
Idiomas disponibles
Idiomas disponibles
2. Route the Black and White wires
exiting the top of the light kit plate
through the center hole on the bottom
of the switch cup.
3. Connect the Black and White wires
exiting the light kit plate with the Blue
and White wires exiting the switch cup
by connecting the 1-positioned molded
adaptor plugs together (Black to Blue ;
White to White).
4. Align the two key slotted holes in the
light kit plate with the two mounting
screws that were loosened in step 1 ,
place the light kit plate over the two
mounting screws and rotate the light
kit plate to the right until it locks. Align
the two non-slotted holes in the light kit
plate with the two screw holes in the
bottom of the switch cup , install the
other two mounting screws that were
removed in step 1 and secure firmly
(Figure 17a).
All manuals and user guides at all-guides.com
5.
Remove the three mounting screws
on the light kit bracket below tbe motor.
6.
Connect the wires exiting the
bottom of the motor with the light kit by
connecting the 9 positioned molded
adaptor plugs together.
7. Slide the light kit and secure it to the
light kit bracket using the three screws
that were removed in step 5 (Figure
17b).
8.
Remove the finial, bottom cover,
and then remove the two hex nuts and
one rubber washer from the threaded
tube, install the threaded tube onto the
stem of the light kit assembly and secure
with one of the two hex nuts (Figure
17b).
9.
With power off, insert 2 candelabra
base bulbs into the sockets, Max. 60w
(provided).
WARNING:Over lamping the fan will
result in the fan lights shutting down until
the proper wattage of bulbs are installed.
Reset the lights by turning off, replace bulbs
with the correct wattage bulbs,Turn power
on.
10. Raise
the
glass
decorative glass accent up against the
light kit assembly and secure properly
with rubber washer and the hex nut, DO
NOT OVERTIGHTEN THE HEX NUT,
OVERTIGHTEN THE HEX NUT MAY
CAUSE GLASS TO BREAK. Finally
secure with the bottom cover and the
finial (Figure 17b).
NOTE: ALLOW THE BULBS TO
COOL
COMPLETELY
TOUCHING OR REPLACING THE
BULBS TO AVOID ACCIDENTAL
BURNING OF THE SKIN.
(provided)
shade
and
BEFORE
10.
Publicidad
