Auto-Switch Off - Koenic KHC 502 P Manual De Instrucciones

Congratulations!
Thanks for your purchase of a KOENIC product.
Please read this manual carefully and keep it
for future reference.
Intended use
This product is only suitable for hair styling.
Any other use can lead to damage to the
appliance or injuries.
Part list
Curling Iron
A
Spring-loaded tongue
B
Temperature control knob + -
C
On-/Off switch
D
Power cord with swivel joint and plug
E
Display panel
F
Stand
G
Content of packaging
1 x Hair Curler
1 x user manual
1 x warranty card
Before first use
Remove the product and accessories carefully
from the original packaging. It is recommended
to keep the original packaging for storage. If
you wish to dispose of the original packaging,
please observe applicable legal provisions.
Should you have any questions regarding
proper disposal, contact your local waste
management center. Inspect the delivery
contents for completeness and damages.
Should the delivery contents be incomplete
or damaged, contact your sales outlet
immediately. After unpacking, please refer to
chapter Cleaning and care.
Curls styling
Divide the hair before styling. Smoothen out
the underlying strands first.
Plug the mains plug into a wall socket.
1
Press the on/off switch to turn on the
2
product.
IM_KHC502P_150212_V01_HR.indb 11
Set a temperature.
3
Hair type
Fine, dyed or
bleached
Normal
Thick or strong
The set temperature is shown on the
4
display.
Press down the lever and place a strand
5
of hair between the curling iron and clamp
tongue.
Note:
• Thinner streak for smaller curls
• Larger streak for broader waves
Now, rotate the curling iron in order to wrap
6
the hair around the rod. Wait for about 10
seconds, until the lock has formed.
Again unwind the strands of hair from the
7
curling iron and open the clamp tongue.
Allow the hair to cool before styling.
Turn off the product after use.
8

Auto-switch off

For safety reason, the product
will switch off automatically
after 60 minutes.
Cleaning and care
Note: Never use solvents or abrasive cleaning
agents, metal, or pointy objects for cleaning.
Disconnect the power plug and allow the
9
device to cool off prior to cleaning.
Clean the exterior surfaces of the product
10
with a small brush or dry cloth.
Caution: Never submerge the device in
water or any other liquid while cleaning.
Technical Data
Rated voltage:
Rated input power:
Rated frequency:
Protection class:
English
Temperature level
120 °C - 140 °C
160 °C - 180 °C
180 °C - 200 °C
60
min
100 - 240 V~
35 W
50/60 Hz
II
11
12/2/15 4:45 PM