DBI SALA Sealed-Block 3400944 Manual De Instrucciones página 13

Serial Number(s):
Model Number:
Inspected By:
Component: Inspection:
SRL Inspect for loose bolts and bent or damaged parts.
(Figure 13)
Inspect Housing (A) for distortion, cracks, or other damage.
Inspect the Swivel Eye (B) for distortion, cracks, or other damage. The Swivel Eye should be attached
securely to the SRL, but should pivot freely.
The Lifeline (C) should pull out and retract fully without hesitation or creating a slack line condition.
Ensure device locks up when lifeline is jerked sharply. Lockup should be positive with no slipping.
NOTE: SRLs with RSQ should be in Fall Arrest Mode for this test (see Figure 8)
The labels must be present and fully legible (labels are illustrated and defi ned on the back pages of
this instruction).
Look for signs of corrosion on the entire unit.
Swivel Snap Hook & Impact Inspect the Swivel Snap Hook for signs of damage, corrosion, and working condition. Swivel should
Indicator rotate freely. Inspect the Impact Indicator. If the Red Band (A) is displayed (Indicated Mode), impact
(Figure 14) loading has occurred and the SRL must be removed from service and inspected. Do not attempt to
reset the Impact Indicator. Return the SRL to an authorized service center for resetting. NOTE: The
Swivel will not turn freely when the Impact Indicator is in Indicated Mode.
⌧
displaying (Indicated Mode); contact Capital Safety regarding service by an Authorized Service Center,
or replace the FAST-Line Lifeline per the instructions in the "FAST-Line Lifeline Replacement Kit Service
Manual (5903076)" and complete the Competent Person inspection.
FAST-Line Wire Rope Lifeline Inspect wire rope for cuts, kinks (A), broken wires (B), bird-caging (C), welding splatter, (D)
(Figure 15) corrosion, chemical contact areas, or severely abraded areas. Slide the cable bumper up and inspect
ferrules for cracks or damage and inspect the wire rope for corrosion and broken wires. Replace the
lifeline if there are six or more randomly distributed broken wires in one lay, or three or more broken
wires in one strand in one lay. A "lay" of wire rope is the length of wire rope it takes for a strand (the
larger groups of wires) to complete one revolution or twist along the rope. Replace the lifeline if there
are any broken wires within 1 inch (25 mm) of the ferrules. Replace the lifeline if the Reserve Lifeline
Band is pulled out of the SRL and is visible.
⌧
contact Capital Safety regarding service by an Authorized Service Center, or replace the FAST-Line
Lifeline per the instructions in the "FAST-Line Lifeline Replacement Kit Service Manual (5903076)" and
complete the Competent Person inspection.
RSQ Components A hand pull test should be performed on RSQ™ Components prior to each use:
(Figure 16)
1. Set RSQ Engagement Knob to Descent position (Diagram 4).
2. Grasp the lifeline and pull fi rmly to engage descent mechanism.
3. Continue to smoothly pull out approximately 3 feet (1 m) of cable. Steady resistance should be
Retrieval Integral Rescue Hand Inspect the Crank Arm (A) for distortion or other damage. Ensure that the Retrieval Handle (B) can be
Crank folded out and secured in the cranking position.
(Figure 17)
Ensure the Retrieval Shift Knob (C) can be pulled out to the unlocked position and then released,
locking the Crank Arm in both the engaged and disengaged positions.
Test the retrieval feature for proper operation by raising and lowering a test weight of at least 75 lbs
(34 kg). When the Retrieval Handle is released, the weight should not move and the Retrieval Handle
should remain in position (no movement). A 'clicking' sound should be audible when raising the load.
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Table 2 – Inspection and Maintenance Log
FAST-Line Means LIFETIME: If the Red Band on the Swivel Snap Hook Impact Indicator is
FAST-Line Means LIFETIME: If inspection in the previous step indicates lifeline replacement;
felt when pulling out cable.
Date Purchased:
Date of First Use:
Inspection Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
13
Authorized
Person or Competent
Rescuer Person