Kärcher KM 150/500 R Bp Manual Original página 22

Installation position of roller brush in direc-
tion of travel (top view)
Note: When installing the new roller brush,
ensure correct positioning of the bristle as-
sembly.
 Install new roller brush. The nuts of the
roller brush must be inserted on the
notches of the opposite crank.
Note: Once the new roller brush has been
installed, the sweeping track must readjust-
ed.
Check and adjust roller brush sweeping
track
 Check tyre pressure.
 Switch off suction blower.
 Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
 Set the programme switch to sweep
with roller brush.
 Set programme selection switch to
"Transport drive".
 Drive machine backwards.
 Check sweeping mirror.
The sweeping track should have an even
rectangular shape which is 80-85 mm
(3.15-3.35 inches) wide.
Adjusting the sweeping track:
1 Adjusting screw
 Adjust the sweeping track position by
adjusting the adjustment screw.
 Check sweeping mirror.
Check and adjust sweeping track of the
side-brush
 The side-brushes lift up.
 Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.
 Set the programme switch to sweep
with roller brush and side brush.
 The side-brushes lift up.
 Set programme selection to "Drive".
 Drive machine backwards.
 Check sweeping mirror.
The width of the sweeping track should lie
between 40-50 mm (1.57-1.97 inches).
 Set the sweeping track using the two
adjusting screws.
 Check sweeping mirror.
Adjust the side seals
 Drive the waste container up and se-
cure it with the safety rod.
DANGER
Risk of injury! Always apply the safety bar
when the waste container is raised.
 Fold the safety rod for the high empty-
ing up and insert it into the holder (se-
cured).
1 Holder of safety rod
2 Safety rod
 Open the side cover as described in
Chapter "Replace brush roller".
EN
8
-
 Release the 6 wing nuts on the side
holding plate.
 Loosen 3 nuts (SW 13) on the front
holding plate.
 Press the side seal down (elongated
hole) until it is about 1 to 3 mm to the
floor.
 Screw in the holding plates.
 Repeat the procedure on the other side
of the appliance.
Manually clean the dust filter
 Clean the dust filter with the filter clean-
ing button.
Replacing dust filter
WARNING
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.
 Open the lock, remove the star grip
screw to do this.
 Fold cover forwards.
2
1
 Open filter cap.
 Fold the filter vibrator forward.
21