Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching the tether straps
Some vehicles may already be fitted with anchorage points at the base of the front
seat rails, or, if installing in the front passenger seat, in front of that seat.
If your vehicle does not have these anchor points, the supplied lower anchor
8
straps must be used.
For installation in the back seat, feed the buckle end of the anchor strap
9
through either the rear of the front seat rails, or the hinge of the front seat. The
anchoring point needs to be as close to the floor as possible. In doing so you
should always insert the buckle of the anchor strap through the closest appropriate
slot in the strap to create a slip knot then pull tight. This needs to be repeated on
both sides to create two anchor points.
When installing Rekid in the front passenger seat the lower anchor straps must
10
be attached to the front gliding tracks so the anchor points will be located
along the front edge of the passenger seat.
Pull out the upper tether strap from the belt housing (N) to an appropriate
11a
length.
Check that the white marking on the strap (i) is visible. If not, you can try
12a
crossing the straps over (ii) to give them some extra length to enable the white
marking to be visible.
Clip the anchor attachments directly onto the vehicle anchorage points (or
13a
lower anchor straps if you have used them). Press down hard on the top of
one side (i) of the child restraint then repeat on the other side (ii). When you
do this it's important that you really use your full body weight to press down and
get the tether straps to really tighten hard. This will give the tether straps their first
tightening.
Unfold the support leg (R) out to its maximum angle. Pull out the top latch (S)
14a
to release the upper part of the support leg until it reaches the floor. If the
support leg does not reach the floor, repeat with the lower latch (T).
It is important that you check that the support leg is at an angle over 80
15a
degrees from the back of the seat. You could check this by ensuring that the
support leg is further away from the seat than the vertical line.
Press down on the child restraint from side to side again (i)(ii), the tether straps
16a
will be then be automatically tightened.
All manuals and user guides at all-guides.com
7
Publicidad
