Anet A8 Manual Del Usuario página 13

2.2 Filament Installation （take PLA for example）
All manuals and user guides at all-guides.com
(1) Peheating： ： Main Menu "Quick Settings" → "Preheat PLA" .Enter preheating state.
(2)Install Filament： When the preheating temperature reaches the setting data, push the filament into
tube as below. It means installation successes if the material overflows from nozzle.
(Also need preheat the nozzle when pull out the filament from extruder.)
Be careful with hot
hands
2.3 Print Operation
Choose Print File： Main Menu "SD Card" → "Print file" → "Model File" Confirm.
After the extruder and hot bed reach the setting temperature， the extruder starts moving and print.
More details about operation and user guide, welcome to visit www.anet.com.
Warning,Do not toch hot surface
The thumb presses the screw head of the
extrusion head, and the index finger holds
the air guide. Quickly push the
consumables down until the nozzles are
spitting out.
12