Electro Depot VALBERG 14S42 C XAD929C Instrucciones De Uso página 18

B
• A 20A circuit breaker or a 16A fuse on the appliance's dedicated circuit must be used.
The cross-section of the supply cables must be 2.5 mm² and the differential switch, 30 mA.
• The outlet must be equipped with a protective ground plug. If the plug is unsuitable or
damaged, replace it and check the electrical installation to ensure that it meets the above
requirements.
WATER INLET AND OUTLET
Cold water connection
• Connect the cold water supply hose to a 1.9 cm threaded fitting and ensure that it is
tight.
• If the water supply pipes are new or have not been used for a long time, let the water run
to check it is clear. This is required to avoid the risk of the water supply being blocked,
which could damage the appliance.
CAUTION
A hose connected to a spray tap can burst if it is installed
on the same water pipe as the dishwasher. If your sink is
equipped with one, it is recommended disconnecting the
pipe and blocking the hole.
How do I disconnect the safety inlet hose?
1. Close the water supply.
2. Unscrew the safety inlet hose from the tap.
CONNECTING THE DRAIN HOSES
• Insert the drain hose into a drain pipe with a minimum diameter of 4 cm, or let it run
into the sink, being careful to avoid bending or pinching the hose. The height of the drain
Using the appliance
11 EN