Cooling System; Wall Mounting - Makita DC40RB Manual De Instrucciones

Cooling system

This charger is equipped with cooling fan for heated
battery in order to enable the battery to prove its own
performance. Sound of cooling air comes out during
cooling, which means no trouble on the charger.
Blue and red light will flash alternately for warning in the
following cases.
• Trouble on cooling fan
• Incomplete cool down of battery, such as, being
clogged with dust
The battery can be charged in spite of the alternate blue
and red light. But the charging time will be longer than
usual in this case. Check the sound of cooling fan, vent
on the charger and battery, which can be sometime
clogged with dust.

Wall mounting

WARNING:
Make sure to use four screws when mounting the charger on the wall. Otherwise the char-
ger may fall and cause serious injury.
WARNING:
Always be sure that the charger is unplugged and all the batteries are removed from the
charger before performing wall mounting work.
WARNING:
Follow the steps instructed in this manual, and complete the whole procedures at once.
The charger may fall and cause injury or damage if you stop the work in the half way.
WARNING:
Check tightness of the screws on regular basis. Otherwise the charger may fall because of
loosen screw.
WARNING:
Clean the terminal parts of the charger on regular basis with an air duster etc.
CAUTION:
Carefully choose a stable wall for mounting the charger. Make sure there is no hindrance
to mounting work or charging operation. The gross weight of the charger and battery reach approximately
6.0 kg (13 lbs). Provide sufficient reinforcement for the wall if necessary.
CAUTION:
Be careful not to drop the battery cartridge when inserting or removing the battery from the
wall-mounted charger. Hold the battery cartridge firmly and keep a stable posture.
You can mount the charger on the wall. Make a clearance around the charger as shown in the figure.
► Fig.3
NOTE: Things you need to prepare:
— Four screws - two for hanging and two for anchoring
Screw size : 6 mm x more than 40 mm.
Screw head size : Less than ø12 mm.
— Tools - for tightening screws
1. Fix two screws for hanging on the wall.
2. Remove the rubber feet (four pieces) from the bottom of the charger.
3.
Hang the charger with the screws fixed in step 1.
► Fig.4
4. Mount the charger on the wall by tightening two anchoring screws completely.
► Fig.5
Always keep clean the vent on charger and battery for
cooling.
► Fig.2: 1. Exhaust vent 2. Intake vent
NOTE: The cooling system is in order although no
sound of cooling fan comes out, if the blue and red
light will not flash.
NOTE: The products should be sent to repair or
maintenance, if the blue and red light flashes alter-
nately so often.
7 ENGLISH