Optional Accessories - Makita M6600 Manual De Instrucciones

Installing the mixing blade
► Fig.5
To mount the mixing blade, install it with the " UP " mark
on it facing the tool (directing inside).
Install the mixing blade on the top of shaft and secure it
with hex bolt.
► Fig.6: 1. Mixing blade 2. Shaft 3. Hex bolt
In case of mixing blade 150 (accessory), screw it
directly on the top of shaft as it is threaded.
Installing top grip (auxiliary handle)
► Fig.7
Screw the top grip on the tool securely.
Installing back grip (country specific)
► Fig.8: 1. Leaf spring 2. Rear handle 3. Boss
Pull off the cap from the tool housing. Insert the leaf
springs into the groove of the handle part that has the
bosses. Then attach them to the bottom of the tool
housing.
► Fig.9: 1. Rear handle 2. Screw
Attach both of the handle parts and tighten them with
the screws securely.
OPERATION
CAUTION:
Do not mix flammable materials or
operate the tool around flammable materials such
as paint with thinner used as solvent. Failure to do
so may cause an injury.
CAUTION:
When you mix the material while
the mixing blade floating out of the material, be
careful not to splash the material.
► Fig.10
1. Always use the top or back grip (auxiliary handle)
and firmly hold the tool by top or back grip and switch
handle during operations.
2. Place the mixing blade under material fully and
turn on the tool after making sure work site safety.
3. Move the mixing blade up and down during the
mixing operation so that whole part of material can be
mixed.
4. When finishing mixing, turn off the tool, make sure
that the mixing blade has come to a complete stop, and
then pull it out of the mixing container.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Replacing carbon brushes
► Fig.11: 1. Limit mark
Check the carbon brushes regularly.
Replace them when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
1.
Use a screwdriver to remove the brush holder
caps.
2. Take out the worn carbon brushes, insert the new
ones and secure the brush holder caps.
► Fig.12: 1. Brush holder cap
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Mixing blade
Type
Mixing blade 130
Mixing blade 150
Mixing blade 165
• Shaft
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
6 ENGLISH
Maximum diameter Twin blade
possible
130 mm
150 mm
165 mm
-
-
-