Operate The Professional 3400 And 5400N System; Power On The System; Power Off The System - Rimage Professional 3400 Guia Del Usuario

Operate the Professional 3400 and 5400N System

This section provides the information needed to operate your system.

Power On the System

1. Press the power switch on the rear of the
autoloader. The system powers on, including the
integrated printer.
If you have an 5400N, continue with step 2.
2. On the front of the 5400N, press the PC
power button to power on the embedded
PC.

Power Off the System

1. Close all open applications.
2. If you have an 5400N briefly press the PC power button. This shuts down the software, Windows, and the embedded
PC.
If you have a 3400, continue with step 3.
n
Caution: Do not press and hold the PC power button. If you press and hold the PC power button, the embedded PC
will not shut down properly. This may cause data loss or corruption.
3. Press the main power switch to power off the system, including the integrated printer.
-
Important! Do not press the power switch until the embedded PC is completely powered off.
 Notes:
• It takes approximately 30 seconds for the system to power off.
• If the printer is idle for more than 30 minutes, it enters sleep mode. When this occurs, the printer will take 2-3
minutes to warm up after a job is sent.
2001431_B
All manuals and user guides at all-guides.com
PC Power Button
(5400N Only)
Power Switch
19