Makita 6096D Manual De Instrucciones página 5

• Drilling in metal
To prevent the bit from slipping when starting a hole,
make an indentation with a centerpunch and hammer
at the point to be drilled. Place the point of the bit in the
indentation and start drilling.
Use a cutting lubricant when drilling metals. The excep-
tions are iron and brass which should be drilled dry.
CAUTION:
• Pressing excessively on the tool will not speed up the
drilling. In fact, this excessive pressure will only serve
to damage the tip of your bit, decrease the tool perfor-
mance and shorten the service life of the tool.
Drilling and driving performance
The following reference table indicates the approximate drilling and driving capacities from a single battery charge. It
may differ under some conditions.
Dimensions
Application
of hole
3 mm
6.5 mm
Metal
3 mm
10 mm
9 mm
Wood *15 mm
*18 mm
Application
Wood screws
(*...350 tr/mn)
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and the bat-
tery cartridge is removed before carrying out any work on
the tool.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a
Makita Authorized Service Center.
All manuals and user guides at all-guides.com
Workpiece
Cold-rolled steel
sheet or plate
Aluminun sheet
Medium hard wood
Dimensions of
wood screw
3.5 mm x 20 mm
4.5 mm x 20 mm
Medium hard wood
*5.1 mm x 35 mm
*5.5 mm x 50 mm
• There is a tremendous force exerted on the tool/bit at
the time of hole breakthrough. Hold the tool firmly and
exert care when the bit begins to break through the
workpiece.
• A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back out.
However, the tool may back out abruptly if you do not
hold it firmly.
• Always secure small workpieces in a vise or similar
hold-down device.
• If the tool is operated continuously until the battery car-
tridge has discharged, allow the tool to rest for 15 min-
utes before proceeding with a fresh battery.
Thickness
Battery 9000
1.6 mm
1.6 mm
25 mm
Workpiece
Battery 9000
500 screws
400 screws
90 screws
60 screws
ACCESSORIES
CAUTION:
These accessories or attachments are recommended for
use with your Makita tool specified in this manual. The
use of any other accessories or attachments might
present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita service center.
• Phillips bit
• Slotted bit
• Socket bit
• Drill bit for steel
• Drill bit for wood
• Rubber pad assembly
• Foam polishing pad 125
• Wool bonnet 100
• Battery cover
• Various type of Makita genuine batteries and chargers
No. holes
Battery 9033
230 380
50 80
750 1,250
120 200
350 590
100 160
60 100
Fastenings
Battery 9033
850 screws
650 screws
150 screws
100 screws
5