Product Information; 11 Troubleshooting - Philips CE233 Manual Del Usuario

10 Product
information
Note
•
Specifications are subject to change without prior
notice.
General
Power supply 12 V DC (11 V - 16 V),
negative ground
Fuse 15 A
Suitable speaker 4 - 8
impedance
Maximum power 50 W x 4
output
Continuous power 22 W x 4 RMS
output (4
Pre-Amp output 2.5 V
voltage
Aux-in level 500 mV
Dimensions 188 x 58 x 110 mm
(W x H x D)
Weight 0.63 kg
Radio
Frequency range 87.5 - 108.0 MHz (100
- FM kHz per step in auto
search and 50 kHz per
step in manual search)
Usable sensitivity 8 µV
- FM (S/N = 20 dB)
Frequency range 522 - 1,620 KHz (9 KHz)
- AM(MW) 530 - 1710 KHz (10 KHz)
Usable sensitivity 30 µV
- AM(MW)
(S/N = 20 dB)
EN
18
10% T.H.D.)

11 Troubleshooting

Warning
•
Never remove the casing of this product.
To keep the warranty valid, never try to repair
the product yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact the
Consumer Care, make sure that the product
is nearby and the model number and serial
number are available.
No power or no sound.
•
The power supply from car battery is cut
off, or the car battery runs out of energy.
Power the system with car battery.
• Car engine is not on. Turn the car engine
on.
• Cable is not correctly connected. Check
connections.
•
The fuse is burnt. Replace the fuse.
•
Volume is too low. Adjust volume.
•
If the above solutions cannot help, press
the RESET button.
• Make sure that the current track is in a
compatible format.
Noise in broadcasts.
•
Signals are too weak. Select other stations
with stronger signals.
• Check the connection of the car antenna.
• Change the broadcast setting from stereo
to mono.
Preset stations lost.
• Battery cable is not correctly connected.
Connect the battery cable to the terminal
that is always live.
Display shows ERR-12.
• Data error. Check the USB storage device
or SD/SDHC card.