Attaching The Handle - Provo Craft Cuttlebug Manual Del Usuario

Thank You!
Congratulations, and thank you for purchasing the
Cuttlebug Die Cutter and Embosser . Cuttlebug
™ ™
was designed with your creative needs in mind.
It's easy, portable, and compatible with other die-cutting systems.
Cuttlebug will launch you into a new dimension of paper crafting possibilities.
Please read all the information in this pamphlet before using your new Cuttlebug system.
Inside your box
You will find the following inside your box:
• Cuttlebug Die Cutter and Embosser
• Spacer block A
• Two cutting pads B
All manuals and user guides at all-guides.com
• Thin die adapter C
• Hex key tool
• User manual • Screw
• Handle • Plastic cap
Fig 1

Attaching the handle

• Position handle on machine post • Turn screw with hex key tool
and insert screw into handle. until tight.
Setting up
1. To activate the Cuttlebug machine's suction system, place the machine on a dry,
flat, and smooth surface where it can have 15 inches of space in front and back.
2. Lower both platforms at the same time by pressing them down until they are
perpendicular to the Cuttlebug machine. Lowering the platforms activates the
suction mechanism that will hold the Cuttlebug
machine in place.
Fig 3
Fig 2
• Place plastic cap.