Additional Instructions For Work With The Battery Pack - SPARKY BR2 12E Instrucciones De Uso Originales

Taladro atornillador a batería
Ocultar thumbs Ver también para BR2 12E:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 44
into contact with the charger. There is a danger of
electric shock.
charging the exact type of SPARKY rechargeable
battery pack as supplied with the charger. Any other
use may result in the risk of fire or electric shock.
specifically designed to work together. Do not attempt
to charge the battery pack with any other charger than
the one supplied.
could cause overheating. Do not place the charger
near any heat source.
from the power source.
will not be stepped on, tripped over or otherwise sub-
jected to damage or stress.
necessary. The use of an improper extension cord
could cause the risk of fire or electric shock.
heavy knock, dropped or otherwise damaged in any
way. Do not operate charger with damaged cord or
plug - have them replaced immediately. Take the
charger to an authorised service centre for a check or
repair.
ised service centre when service or repair is required.
Incorrect re-assembly may result in the risk of fire or
electric shock.
charger from the power supply before attempting to
clean it. Removing the battery alone does not reduce
the risk.
cations where the temperature may reach or exceed
metal structures during summer.
household electrical supply (230–240V). Do not at-
tempt to connect the charger to a supply with a differ-
ent supply.
the charger from the mains supply and leave it for at
least 15 minutes. After this time you can charge a sec-
ond battery pack.
to the power supply, the exposed charging contacts
inside the charger can be shorted by foreign material.
not limited to, steel wool, aluminium foil, or any build-
up of metallic particles should be kept away from
charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cav-
ity. Unplug charger before attempting to clean.
other liquid.
6
EN
Do not allow any liquid to come
Additional instructions
for work with the
battery pack
low charge condition. You should charge the battery
pack fully before use.
damaged in any other way, do not insert it in the charg-
er. There is a danger of electric shock.
performance, always charge the battery when the air
temperature is between 18–24°C.
Do not charge the battery pack when the temperature
to observe this safety rule could cause serious dam-
age to the battery pack.
touch while charging. This is a normal condition, and
does not indicate a problem.
in direct sunlight in hot weather or near heat sources.
The battery must be placed in a well ventilated area
during charging
may occur under extreme usage or temperature con-
-
ditions. This does not indicate a failure. However, if
the outer seal is broken and this leakage gets on your
skin:
Wash quickly with soap and water.
Neutralise with a mild acid such as lemon juice or vin-
egar.
If battery liquid gets into your eyes, flush them with
clean water for a minimum of 10 minutes and seek
immediate medical attention.
-
(
The liquid is 25-35% solution of potas-
sium hydroxide.)
(1) Check current at receptacle by plugging in a lamp
or other appliance.
(2) Move charger and battery pack to a location where
the surrounding air temperature is approximately
(3) If charging problems persist, take or send the tool,
battery pack and charger to your local service centre.
produce sufficient power on jobs, which were easily
done previously. DO NOT CONTINUE to use under
damaged or can no longer hold a charge. The battery
pack can explode in a fire.
avoid placing the charger or battery pack in a warm
environment such as in a metal shed, or an uninsu-
lated trailer.
If the battery pack is cracked or

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Br 15eBur2 15eBur2 18e

Tabla de contenido