Operating Tips; Cleaning And Maintenance; Cleaning; Maintenance - AmazonBasics B0853PBGCD Instrucciones

C
Batteries are located in the battery housing
behind the light fixture� Select the OFF position
on the light prior to opening the battery
housing� Remove the four screws to reveal
the batteries�
When replacing the batteries, observe correct
polarity and match the battery specification
with the batteries you have removed� Use
rechargeable batteries only�
D
Connect the wire from the solar panel into the
socket located under the light fixture�
The solar motion light will now begin to charge�

7. Operating Tips

» Check for things obstructing light
reaching the solar panel like over hanging
branches, fences or buildings� If there are
obstructions, move the solar panel to a
location receiving better light throughout
the day�
All manuals and user guides at all-guides.com
» The solar panel must be clean� A dirty
solar panel will not let the battery charge
fully� This will shorten the life of the battery
and stop the light operating�
» The sensor is light sensitive� For night
usage, ensure there is no other light
activating the motion sensor�
» From time to time, ensure the plug
between the solar panel and light is
securely connected�
» It is advisable to adjust the angle of the
solar panel to optimize the exposure of
the sun in winter�

8. Cleaning and Maintenance

NOTICE
Set the switch to OFF
position and disconnect the light from the
solar panel before cleaning�
8.1

Cleaning

» The solar panel should be cleaned by a
damp cotton cloth on a regular basis�
This will ensure optimal performance
and battery charging� Periodically, utilize
the same way to clean the lenses of the
security light�
» To clean the product, wipe with a soft,
slightly moist cloth�
» Never use corrosive detergents, wire
brushes, abrasive scourers, metal or
sharp utensils to clean the product�
8.2

Maintenance

» Remove the batteries and make sure
that the light unit is switched off for long
periods of storage�
» Any other servicing than mentioned in
this manual should be performed by a
professional repair center�
EN
7