Troubleshooting; Fcc - Supplier's Declaration Of Conformity; Fcc Compliance Statement - AmazonBasics B0853PBGCD Instrucciones

EN

9. Troubleshooting

Problem
Where should the solar panel
be mounted?
Does the solar panel require
direct sunlight to charge?
Can additional or extended
cable wire for the solar panel
be purchased?
Why does the solar motion
light appear to strobe or flash?
Will decorative light or street
light affect the operation ability
of motion sensor?
What type of battery does my
solar motion light require to
operate?
10. FCC – Supplier's Declaration of Conformity
Unique Identifier
Responsible Party
U�S� Contact Information
Telephone Number
10.1

FCC Compliance Statement

1� This device complies with Part 15 of the
FCC rules� Operation is subject to the
following two conditions:
(1) this device may not cause harmful
interference, and
8
All manuals and user guides at all-guides.com
Solution
» Mount the solar panel in a position that enables the
most amount of light to be absorbed (refer to Step 1
on page 4)� In the northern hemisphere, this is usually
south facing�
» The solar panel can charge the internal batteries in
direct and indirect light� For best results, try to optimize
the solar panel's exposure to sunlight�
» At this point there are no extensions available for the
cable that connects the light to the solar panel� Any
additions to the cable will void the warranty�
» A quick flicker is caused by undercharged batteries� Turn
off the security light and charge it for two sunny days until
its fully charged� Then switch it to AUTO mode�
» Yes, it will� The sensor of security light is light-sensitive�
For night usage, ensure there is no other light activating
the motion sensor�
» The solar motion light requires the use of 2 x 3�7 V
1800 mAh Li-Ion (type 18650) rechargeable batteries�
B0853PBGCD - Waterproof LED Solar-
Powered Outdoor Security Light with Motion
Sensor and 2 Adjustable Heads, Wide Angle
Illumination, 1500 Lumen
Amazon�com Services LLC�
410 Terry Ave N�
Seattle, WA
98109, United States
(206) 266-1000
(2) this device must accept any
interference received, including
interference that may cause
undesired operation�
2� Changes or modifications not expressly
approved by the party responsible
for compliance could void the user's
authority to operate the equipment�