Classic Accessories 52-002-010401-00 Instrucciones página 7

INSTALL THE CENTER AND SIDE MOUNTING BARS
(fIG. 5)
5. Slide side mounting bars [B1, B2] through each upper
mounting post. Connect the center mounting bar [A] to
both side mounting bars by engaging the spring loaded
pins as shown. (Fig. 5)
6. Snug but do not fully tighten. Leave the nuts loose for
final adjustments of the mounting posts. Tighten set
screws on the lower mounting posts with supplied Allen
wrench [P]. Fig. 4
ASSEMBLE THE REST Of THE fRAME (fIG. 6)
7. Insert the mounting bar ends [C1, C2] into the side mounting bars
by engaging the spring load pins.
8. Install each front pole [D1, D2] into the protruding stud on the top
of each side mounting bar.
Note: You must first remove the protective plastic caps off the
protruding studs on each side mounting bar [B1, B2].
9. Insert the back hoop side poles [E] first into each side mounting
bars. Insert another pair of back hoop side poles into the tops of
the ones installed on the side mounting bars. Insert the back hoop
corner poles [F] into the tops of the installed sections of back hoop
side poles. Finish by inserting the back hoop top pole [G] into both
back hoop corner poles.
Note: It may help to place the parts flat on the
ground for easier assembly.
Note: The back hoop side and corner poles each
have clear plastic sleeves on one end. The frame
hoop top pole DOES NOT have
clear plastic sleeves.
Remove protective plastic
caps from these metal studs
prior to assembly
B1
D1
C1
7
B2
A
fig. 5
f
G
E
E
fig. 6
D2
f
E
E
C2