Hints - Vita5 Nobel PRO Manual Del Usuario

EN
1. Put the clean food in the trays
– Do not overload the trays and never overlap the food. Close the damper door.
2. Plug dehydrator into wall outlet, the screen and button light up and there is a beep sound at the begin-
ning when it starts up. And the ON/OFF" light up, the screen shows "----".
3. Press the "ON/OFF" button, The LED screen will show default time setting "10:00" and temp setting "70ć".
Motor and fan start first, then heating element start working 5 seconds later. Set time begins to count
down, the signal ":" on LED screen flashes.
4. Press the "TEMP/TIME" button and LED screen shows the time value. According to actual needs, press "+" or
"-" button to change the drying time between "0:30" and "24:00". Press "+" or "-" button once, the time
increment or decrement is 30 minute/press. If press "+" or "-" button for long time, then it automatically
increases or decreases. After finish setting the drying time, system automatically gets into operating mode
in current time setup.
5. Press the "TEMP/TIME" button and LED screen shows the temp value. According to actual needs, press "+"
or "-" button to change the drying temp between "35ć" and "75ć". Press "+" or "-" button once, the temp
increment or decrement is 5ć/press. If press "+" or "-" button for long time, then it automatically increases or
decreases. After finish setting the drying temp system automatically confirms to work in current temp
setup. LED screen operating in time mode.
Note: Set low temperature for thin/small pieces of food or for a small load of food. Set
high temperature for drying thick/big pieces of food and large loads. The thermostat can
also be used to decrease the temperature as the food is near the end of its drying cycle
making it easier to control the final moisture level in the food.
6. During drying process, you can change or check the drying time. Press the "TEMP/TIME" button first, then
press the "+" or "-" button. Press "TEMP/TIME" button, you can check the setting time.
7. During drying process, press the "ON/OFF" button, all functions will be paused after 10
seconds. Screen no display.
8. In standby mode, you can press the "ON/OFF" button directly to get into default mode ( TIME : 10 hours
TEMP: 70ć). You also can change the drying time and temp if needed.
9. When the set time counts down to "0:00", the LED screen shows "End". And the heating element stops
working first, the fan will continue running for 10 seconds and the buzzer rings 20 times "beep" sound (1
time/second).
10. Unplug the unit from the power point.
•
This dehydrator includes 10 trays and an overheat protection. The host contains heating elements, motor, fan and thermostat.
•
The air vents on the tray allow air to be circulated.
•
Using a controlled heat temperature, Air from the back ow into each tray drying moisture.
•
Depending on the moisture in the food itself and the humidity in the air, drying operation timecan change. Use the dryer in a
dust free, well ventilated, warm and dry room. Well air ventilation is also important.
•
Fruit and vegetables dried in your food dehydrator will be di erent in appearance from those sold in health food
stores and supermarkets. This is due to your food dehydrator uses no preservatives, no arti cial coloring and only
natural additives.
•
Records of humidity, weight of produce before and after drying times, will be helpful to improving your drying techniques for
the future.

Hints

8.