Initial Operation; Remote Control; Power Supply; Switch Sensowash ® On - DURAVIT SensoWash Slim Manual De Instrucciones

5. Initial operation

Remote control

> Press the lock of the "Battery Compartment"
> Insert two lithium batteries (CR2032) with + facing upwards.
> Close the "Battery Compartment"

Power supply

> Connect the main power supply.
SensoWash
to the power supply. During this time the "Status LED"
EN
only "Power"
Switch SensoWash
Requirement: SensoWash
illuminated.
> Press "Power"
SensoWash
The "Status LED"
All functions can be used.

6. Operating

6.1 Switching the SensoWash
> Press "Power"
A green Status LED indicates "On mode".
> Press "Power"
A red Status LED indicates "Standby mode".

6.2 Shower functions

SensoWash
washing functions are used. The shower functions terminate automatically after
2 minutes or immediately when "Stop"
24
® will start "Initialization" for about 15 seconds when it is connected
A
on the seat unit can work, all other operations will not work.
®
on
® is in the "Standby mode", the "Status LED"
D on the seat unit.
®
is now switched on.
B
is green illuminated.
A on the seat unit to switch on SensoWash
A
on the seat unit again to switch off SensoWash
®
automatically cleans the retracted spray wand before and after
8
to open it.
8 .
®
on / off
7
is pressed.
B flashes green and
B is red
®
.
®
.