Velleman HQ POWER VDP250MH6 Manual Del Usuario página 2

3. General Guidelines
• This device is a lighting effect for professional use on stage, in discos, theatres, etc. The
VDP250MH6 should only be used indoors with an alternating current of max. 230Vac/50Hz.
• Lighting effects are not designed for permanent operation. Operation breaks at regular
intervals will protect the device against malfunction.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device will be protected against extreme heat, moisture and dust.
Respect a minimum distance of 0.5m between the projector's light output and the target
surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not permit
operation by unqualified people. Any damage that may occur will probably be due to
unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short-circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void
the warranty.
4. Installation
a) Lamps
• Only fit or replace a lamp when the device is unplugged from the mains. Replace any
deformed or damaged lamp.
• Let a lamp cool before replacing it as the temperature of a lamp can reach 700°C during
operation.
• Do not touch the lamp with your bare hands when you're installing a halogen lamp. Use a
cloth to insert or remove a halogen lamp.
• Do not install lamps with a higher wattage. They generate higher temperatures than the ones
this device was designed to be able to cope with.
• Insert one 230V/250W lamp (code LAMP250MSD) :
1) Loosen the screws at the back of the housing and open the lid.
2) Replace the old lamp and insert the new one.
3) Close the lid and fix the screws.
Remarks :
1) Do not operate the device when the cover is off.
2) If necessary, you can slightly realign these screws in order to achieve max. light output.
b) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• If the lamp burns out, chances are that the fuse on the rear panel of the base will need to be
replaced as well.
• Replace a blown fuse with a fuse of the same type and rating (see technical details at the
end of this manual) :
VDP250MH6 2 VELLEMAN