Dexter 300DS2.5 Manual De Instrucciones página 146

FR
8. TROUBLE SHOOTING
ES
check the product using this section. In most cases the problem can be solved quickly.
PT
WARNING! Only perform the steps described within these
IT
instructions! All further inspection, maintenance and repair work
EL
specialist if you cannot solve the problem yourself!
PL
Problem
UA
RO
Product does
not start
EN
Product does
not reach full
power
Unsatisfactory
result
Sanding sheet
does not adhere
properly.
The pad is
deteriorating fast.
146
Possible cause
Not connected to power supply
Power cord or plug is defective
Other electrical defect to the product
Extension cord not suitable for
operation with this product
Power source (e.g. generator) has
too low voltage
Air vents are blocked
Sanding sheet is worn
Sanding sheet not suitable for work
piece material
Clean the pad with a brush (page 179).
Make sure the entire surface of the pad
is in contact with the surface to be
sanded to distribute the sanding power
over the entire pad.
Solution
Connect to power
supply
Check by a specialist
electrician.
Check by a specialist
electrician
Use a proper
extension cord
Connect to another
power source
Clean the air vents
Replace with a new
one
Use suitable sanding
paper
Replace it with a
new one
Rotate the pad by hand
(page 175).
Replace the pad
(page 179).