Troubleshooting Table - Beeper AutoLight ALX9 Manual Del Usuario

TROUBLESHOOTING TABLE

Headlamp canʼt be turned ON in dark automatically / Small lamp canʼt be turned
ON in dark automatically: Make sure that the system is activated / Make sure that the electric cable is
connected on the +12V of the battery / Make sure that the detection white wire is correctly connected to the +12V
after-contact / Make sure that the yellow wire of polarity has been correctly selected, in agreement with the
headlights polarity of the vehicle / Make sure that the orange wire of polarity has been correctly selected, in
agreement with the nightlights polarity of the vehicle.
Without headlamp delay function: Make sure that the system is activated / Make sure that the set up
function headlight delay time function is activated (check if one of the LED is well lit on the sensor of luminosity) /
Make sure that the headlights have current after the contact of the vehicle is cut (all the vehicles have a wire that
brings current to the headlights when contact is cut. Connect the yellow and orange wires with this wire of control).
Headlamp canʼt be turned OFF in day light automatically: Make sure that there is no obstacle
in front of the luminosity sensor / Make sure that the luminosity sensor is correctly installed under the windshield,
in order to detect the ambient light.
I canʼt switch high and low beam after the healights are turned ON automatically:
Make sure that the yellow and orange wires were correctly connected with the origin wire of headlights monitoring
system of the vehicle. This original wire should be able to pass from the high beam to the low beam (Note: Every
vehicle has a wire which is able to control the two types of beam).
11