Safety Device; Water Supply - Lavor METIS Manual De Instrucciones

EN
people, animals or things deriving from the non-
compliance with the following instructions.
K6 Check that both the machine and its com-
ponents are undamaged when unpacking them.
Contact your reseller in case of doubts.
K7 Make sure that the rating corresponds to
the factory power line before energising the ma-
chine.
K8 De-energise the machine before any cle-
aning or maintenance activity.
K9 Never leave the machine energised if
unused. Turn the main switch off.
K10De-energise the machine in case of failure
and / or troubles. Do not tamper with its controls
and equipment. Just contact the authorised after-
sales service points for servicing purposes and al-
ways order original spare parts.
K11 The draining and loading pipes, the sa-
fety sheaths and the solenoid valves must not be
cut and tampered with. De-energise the machine
in case of damages
K12 Any use of the machine other than the
one it has been built for represents an anomalous
condition and can cause serious damages to the
operating means and entail a serious risk for the
operator using it.
K13 Never remove or hide the warning labels
applied to the machine.
K14 The same instructions are valid for va-
rious models; some details may differ according
to the machine model.
K15 Never touch or start the machine with
wet hands or bare feet;
K16 Remove the casings and the doors of the
electric boards only once the machine has been
stopped and de-energised;
For fire-prevention purposes:
K18 Keep all inflammable or combustible pro-
ducts away from the equipment area.
K19 Obviously, the above-mentioned instruc-
tions are not sufficient to prevent all sorts of acci-
dents; therefore, the user will have to be cautious.
K20 The machine must not be modified or chan-
ged in any way without the builder's written au-
thorisation.
WARNING: We recommend the use of demine-
ralized water.
WARNING: Never use the power cable or the
gun cable to move it.
> SAFETY DEVICE
WARNING: the gun is fitted with a safety
catch. Whenever use of the machine is
interrupted it is important to operate the
safety catch to prevent accidental activation
of the jet.
Safety features:
- Safety valve
- Manostat
- Thermostat
- Pump with a by-pass valve or stopping device.
> STABILITY
WARNING:
The machine must be always kept
on horizontal bases, in a safe and stable way.
> WATER SUPPLY
Water supply collection
Water supply from the water main
- Connect a supply hose (not included) to
the water inlet of the unit and to the water
supply.
- Open the water supply.
WARNING: (symbol) machine not
suitable for connection to the potable water
mains.
The cleaner can only be connected to the wa-
ter mains if the water mains is separated by a
backflow preventer. Make sure that the hose
is at least Ø 13mm-1/2 inch and that it is rein-
forced.
WARNING: Water that has flown through
backflow preventers is considered to be
nonpotable.
IMPORTANT: Only clean or filtered water
should be used for intake. The delivery of
the water intake tap should be equal to the
double of the maximum pump range.
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the machine as close to the water supply
system as possible.
16