Fellowes Cambio Instrucciones página 3

STEP 4
Assembling the Connection Bars
• Align the 8 mounting holes on the two connection bars with the
screw holes on the lifting columns.
• Attach the connection bars to the lifting columns using 8
countersink Hex Head screws with the Hex Key.
STEP 5
Assemble the feet
• Place the foot on the bottom of the lifting column. Press the foot
into the lifting column.
• Repeat the same process to assemble the other feet.
STEP 6
Assemble the fixing plate
• Align the mounting holes on the fixing plate with the screw holes as shown.
• Attach the fixing plate on the center of the crossbar with 2 Phillips Head screws using a Phillips screwdriver. The fixing plate can be attached to either the right
side or the left side.
• Repeat the same process to assemble the other fixing plate.
*Note: The arrow on the fixing plate indicates the direction of sliding in the control box. Follow the direction of the arrow to mount the control box in the next step.
G
4
CambioBench_411659_RevB_10L_102219.indd 4-5
STEP 7
Connecting cords
• Connect the two motor cords to the two ports on either side of the control box marked "M1"
• Connect the controller cord to the port marked "HS".
• Insert the power cord in the port marked "AC".
O
• Align the fixing plate with the right end of the control box's slot. Slide the control box into the fixing
T
• Repeat the same process on the second desk.
*Note: Please make sure the slot on the control box is facing upward. There is no corresponding relation
D
**Note: The picture of the controller is for your reference only. Actual product may vary.
ACCESSORY INSTALLATION - CABLE MANAGEMENT TRAY
Cable management tray
• Align the mounting holes on the tray hangers with the
• Hang the cable management tray on the crossbar.
• Tighten the knobs on the tray hangers.
• Repeat the same process to assemble the other cable
OR
and "M2".
plate from the left until the control box can't be moved.
between the two motor ports and the two lifting columns.
screw holes on the cable management tray. Assemble
the tray hangers with 4 Phillips Head screws using a
U
Phillips screwdriver.
management tray.
L
H
C
1 2
J
K
5
10/22/19 4:20 PM