Technical Data - Q-Connect QCCB2 Manual De Instrucciones

1 Edge guide
2 Punching Channel
3 Punching and Binding Handle
4 Binding Mechanism
5 Margin Depth Control
6 Waste tray
Setup
Assemble the handle at the vertical start position.
edge alignment
The adjustable Edge Guide allows pages of various sizes to be
accurately aligned for the best punching results.
Move the edge guide left or right and stop at the required position.
Test punching the scrap sheet and re-adjust if necessary.
punChing
With the Punching Handle in the vertical position, align sheets or
covers and insert the edge to be bound into the Punching Channel
and ensure they are aligned to the Edge Guide. Pull the Punching
Handle all the way down.
The QCCB2 can punch max. 10 sheets of 80 gsm paper at once.
Punch max. 1 plastic covers at a time.
Move the punching Handle upwards again and remove the
punched document.
margin depth Control
The QCCB2 comb binder is equipped with a Margin Control knob
for improved document reading and paper strength. It can be
turned either clockwise or counter-clockwise to suit the size of
the document being bound. Generally a small margin depth is
required for small comb sizes and a larger margin depth is
recommended for larger comb sizes.
reCommended Setting
Depth 2 mm, comb size 5mm.
Depth 3 mm, comb size 6mm - 8mm.
Depth 4 mm, comb size 10mm - 12mm.
Depth 5 mm, comb size 14mm - 20mm.
Depth 6 mm, comb size 22mm - 25mm.
Depth 8 mm, comb size 28mm.
binding
Place a plastic comb with the side to be opened upwards onto the
Binding Mechanism. Pull down the Punching Handle so far that the
comb is opened enough.
Position the punched sheets vertically in the open comb. Locate
the punched holes over the open comb fingers and rotate the
sheets forward onto the comb. When all the sheets are loaded
onto the plastic comb, release the Binding Handle to its original
position to close the plastic comb completely. You can now
remove the bound booklet and enjoy your finished work.
All manuals and user guides at all-guides.com
3
emptying the waSte tray
Take out the waste tray from the side of the machine. For best
results, empty the tray regularly.
general SafeguardS
Place the comb binder on a secure and stable work table to
prevent it from falling and causing personal injury and damage to
the machine.
Use the machine only for its intended purpose.
Always test the machine with some scrap paper before punching
the final document.
When punching plastic covers, we recommend to punch the cover
with a sheet of paper on both sides.
Empty the waste tray regularly.
Lift the machine from the bottom, not from the lids or handels.
Unautherized maintenance is not allowed.

teChniCal data

Punching capacity: 10 sheets (80gsm).
Number of punches: 21.
Binding capacity: 250 sheets.
max. Document size: 315mm.
Max. Binding Comb: 28mm.
adjuStable edge guide
Variable punching margin: 2mm - 8mm.
t
W W W . Q - C O N N E C T . C O M