Connect Inlet Hoses - Maytag MVWP575GW Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
Remove drain hose form
(floor drain installations only)
For floor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See "Tools and Parts."

CONNECT INLET HOSES

Washer must be connected to water faucets with new inlet
hoses with flat washers (not provided). Do not use old hoses.
NOTE: Both hoses must be attached and have water flowing
to inlet valves. If you are only connecting to a cold water
faucet, you must use a Y-adapter (not provided).
1.
Connect inlet hoses to water faucets
Attach hose to hot water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings an
additional 2/3 turn. Repeat this step with second hose for cold
water faucet.
IMPORTANT: Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can result.
2.
Clear water lines
Run water for a few seconds through hoses into a laundry tub,
drainpipe, or bucket to avoid clogs. Water should run until clear.
Make note of which hose is connected to hot water to help
in attaching hoses to washer correctly.
3.
Connect inlet hoses to washer
Attach hot water hose to hot water inlet valve marked with
a red ring. Screw coupling by hand until it is snug. Use pliers
to tighten couplings an additional 2/3 turn. Repeat with cold
water inlet valve.
IMPORTANT: To reduce risk of hose failure, replace the hoses
every 5 years. Record hose installation or replacement dates
for future reference.
Periodically inspect and replace hoses if bulges, kinks, cuts,
n
wear, or leaks are found.
4.
Check for leaks
Turn on water faucets to check for leaks. A small amount
of water may enter washer. It will drain later.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido