Uline H-1488 Manual Del Usuario página 3

FOR BINS 3" HIGH
(S-12413 & S-12414)
Attach a crossbar (C) to the fourth hole up from the
bottom using #14 sheet metal screws (E). Skip every
other hole, attach the remaining 11 cross bars with sheet
metal screws. (See Figure 5)
NOTE: Attach each base assembly (A) to the
third hole up using #14 sheet metal screws (E).
(See Figure 5)
FOR BINS 4" AND 5" HIGH
(S-12417, S-12415, S-12418, S-20581,
S-13536 & S-13537)
Attach crossbars (C) to the third and fourth holes from
the bottom using #14 sheet metal screws (E). Skip every
other hole and attach all remaining crossbars in pairs as
shown. The last crossbar at the top is a single crossbar.
(See Figure 6)
NOTE: Attach each base assembly (A) to the
third hole up using #14 sheet metal screws (E).
(See Figure 6)
FOR BINS 7" HIGH
(S-12420, S-12416 & S-12419)
Attach crossbars (C) to the fourth and fifth holes up
from the bottom using #14 sheet metal screws (E). Skip
two holes; attach the remaining crossbars in pairs until
all crossbars are used. The last crossbar at the top is a
single crossbar. (See Figure 7)
NOTE: Attach each base assembly (A) to the
third hole up using #14 sheet metal screws (E).
(See Figure 7)
PAGE 3 OF 15
RACK ASSEMBLIES FOR SPECIFIC ULINE BINS
E
A
Figure 5
E
A
Figure 6
E
A
Figure 7
C
C
C
0521 IH-1488