Important Precautions - XGIMI HALO+ Guia Del Usuario

Important Precautions

Correct use of the device:
Do not face lens into eyes because the strong projector light may cause injury to
the eyes.
Do not block the air inlet/outlet of the device in order to avoid damage to internal
electronic devices arising from normal heat dissipation failure of the device.
Do not wipe the lens directly with cleaning tools including paper and cloth in order
to avoid damage to the lens. Please clean up the dust on the lens surface through
clean air blowing.
Do not wash the device with chemicals, detergents, or any liquid in order to prevent
the circuit board from being corroded by rainwater, moisture, and mineral-containing
liquids.
Keep the device and its components and accessories out of reach of children.
Make sure that the device is used in a dry and ventilated environment.
Do not store the device in overheated or overcooled places, because extreme
temperatures will shorten the life of electronic devices. Place and use the device
in an environment of 0℃-40℃.
Do not put the device into any heating equipment (such as dryer and microwave
oven) for drying.
Do not firmly extrude the device or place barriers on it or its back to avoid damage
to the device.
Do not throw, strike, or sharply vibrate the device to avoid damage to the internal
circuit board.
Do not try to disassemble and assemble the device yourself. If any issue occurs,
please contact the after-sales service of XGIMI.
Do not repair any product on your own. If the device or any component cannot
work properly, consult the after-sales service of XGlMI in a timely manner or return
it to the factory for repair.
Use careful with the earphone maybe excessive sound pressure
from earphones and headphones can cause hearing loss.
As with any bright source, do not stare into the direct beam, RG2 IEC 62471-5:2015.
12