King Innovation KING AL Manual De Instrucciones página 9

KING AL
Determining the Wire Depth
To determine wire depth, follow the instructions above to locate
the wire path. Mark the ground directly above the path. Turn the
receiver sideways to the path, and tip it 45 degrees. Maintaining
the 45° angle, move the receiver away from the wire path until
you detect NULL. Mark this spot and measure the distance
between this spot and the wire path. This is the depth of the wire
(Refer to Figure 5)
FIGURE 5:
Determining Depth
Two-Step Solenoid Valve Locating Process
If all wires leading to a solenoid are intact and the solenoid
is good, then a solenoid valve may be located using the
King AL device.
Follow the instructions shown above to set up the transmitter. Follow
the wire path, detecting NULL and tone sounds, until the signal
becomes extremely strong. When the strong signal is detected,
mark this "hot spot" and move around that area, listening for a
NULL moving away from that area. Follow this NULL tone,
marking any additional hot spots. (Refer to Figure 6).
If only one hot spot is located, this is the valve in question.
I
KING INNOVATION 9