Blaupunkt BP3035 Manual Del Usuario página 5

DESCRIPTION
1. Disk guard
2. Spindle
3. Lock button
4. Side handle
5. Holes for the side handle
(Alternative mounting points)
6. Non-Slip rubber lining
7. Mains Cord
8. On/Off switch
9. Key/wrench for disk installation
10. Fastening flange
11. Grinding disk (not included)
12. Spacing flange
13. Setting screw
14. Speed regulator
15. Safety device
OPERATING INSTRUCTIONS
INSTALLING AND REMOVING THE SIDE HANDLE
ENSURE THAT THE PLUG IS NOT IN THE SOCKET WHEN FITTING OR REMOVING THE AUXILIARY HANDLE.
• To attach the side handle (4) screw it clockwise as deep as it goes into one of the three holes in the tool body. Undo the
handle (4) to remove it
INSTALLING AND REMOVING THE DISK GUARD
1. Place the disk guard (1) on the tool so that the tabs on the guard match the seats in the tool body-the guard will then
be parallel to the tool.
2. Position (rotate) the guard (1) for maximum protection from sparks and debris.
3. Tighten the setting screw with a screwdriver (not included).
4. Reverse steps 1-3 to remove the guard.
CAUTION!
NEVER OPERATE THE TOOL WITHOUT THE GUARD ATTACHED.
ENSURE IT IS IN PLACE AND ATTACHED FIRMLY BEFORE STARTING YOUR WORK.
All manuals and user guides at all-guides.com
EN