General Conditions - EMU CONE Manual Del Usuario

A X 1
E X 1
L X 4
D X 1

GENERAL CONDITIONS:

Carefully remove the product from its packaging. Check that the product is intact and
working properly. Do not attempt to repair or alter the product on your own, this may
void the warranty. Insert the plug to a mains power socket equipped with an earth.
INSTALLING ONTO THE FLOOR:
The product can be installed directly onto the floor by
using n.4 fixing pins especially designed for use with the
floor material itself (fig. 1). The fixing pins insert into the
holes of the base of component A and can be fixed to
the ground as detailed in the indications provided by the
manufacturer of the fixing pins.
CAUTION! The fixing pins are not included in the lamp
pack, since they are adapted to the floor type of each
customer. It is recommended to seek advice regarding
the most suitable type from a trusted retailer.
INSTALLING USING A WEIGHTED BASE:
The product can be installed with an optional WEIGHTED BASE art.2005 (fig.2).
1
C
3
art.2005
H X 1
B X 7
G X 4
F X 1
Tighten the adjustable feet rests B to
the weighted base C. Insert
B
component A into the slot of
weighted base C, being careful not to
damage the tube piece whilst sliding
it in, and fix it by tightening n.4 G
screws (do this task with two
people).
A
L
G
2
C X 1
L X 4
3
4
Assemble the chosen light bulb onto the lamp holder and after fix the lampshade
diffuser, pushing and turning the shade on itself for a short thread.
CAUTION! Only use a light bulb with E27 connection and power less than 150W
Connect the connectors that protrude from
the tube pieces of components A and D
(which join the electrical wires of the two
components), bringing the same parts
together one to the other. Check that the
D
connection is strong.
Push the pole of component A inside
component D and fix together by tightening
screw F.
Lock screw F.
A
F
Assemble lampshade H tightening n.4 bushing pieces to n.4
screws fixed onto the base of the frame structure.
Screw the bushings onto the screws of component D.
It is advisable for this stage of assembly to be carried out by
at least two people.
H
E
H
L
4