General Safety Instructions; Operation; Inserting Or Changing Batteries - Steinbach 061340 Operación Manual

General safety instructions

General notes on batteries
Incorrect use of batteries may cause damage to the adjacent components and personal injury
due to leaking battery fluid.
- Never remove the casing from batteries. Do not short-circuit batteries or attempt to
recharge batteries.
- Always keep batteries away from heat sources, fire or direct sun exposure.
- Use only one kind of batteries per battery pack and do not mix used batteries or battery
packs containing various remaining charge levels with new batteries.
- When inserting the batteries into the battery compartment, make sure that the battery
poles face the right way.
Batteries can leak, especially when they are older. If you come into direct contact with the
battery acid, there is a risk of chemical burns.
- Avoid battery acid coming into contact with your skin, eyes and mucous membranes.
- If you have come into contact with battery acid, wash the affected areas right away with
plenty of clean water and consult a doctor immediately.
- If the battery acid comes into contact with your eyes, immediately rinse your eyes with
cold water for at least 10 minutes. Consult a doctor as soon as possible.
- Remove the leaking batteries from the battery compartment right away.

Operation

The product consists of 2 measuring devices:
- Indoor unit (receiver)
1
- Outdoor unit (transmitter).
14
The outdoor unit is intended for measuring the temperature in the water (e.g. pool, pond) while the
indoor unit measures the inside temperature in the house.
The indoor unit displays both the temperature of the location where it is set up and the water
temperature transmitted wirelessly by the outdoor unit on the display.
Water or other liquids may cause the batteries to short-circuit in the battery compartment.
- Make sure that neither water nor other liquids enter the battery compartment.

Inserting or changing batteries

Outdoor unit
Change the batteries in the outdoor unit
1. Turn the solar light
13
2. Remove the screw
19
3. Open the housing by turning the battery compartment cover
The housing is open.
4. Pull the battery holder
5. Remove the old batteries.
At delivery there are no batteries in the battery compartment.
WARNING!
Risk of injury and damage.
CAUTION!
Risk of chemical burns!
NOTICE!
as soon as the battery symbol
14
counterclockwise to unscrew it from the outdoor unit
to undo the locking device (see Fig. C).
out of the housing (see Fig. D).
22
appears on the display.
3
.
14
counterclockwise.
21
15