Lanaform AllergoLux Manual página 14

2. DIAGRAM AND DESCRIPTION OF THE
PRODUCT
1. Basic appliance
2. Battery compartment
3. Signal light
4. "On" Button
5. Connecting cable for nasal applicator
6. Cable
7. Applicator tip
8. Nasal applicator
3. ACTIVATION /INSERTING THE BATTERY
The AllergoLux appliance operates on a square 6LR61 9V
battery.
Push on the mark located on the battery compartment cover
(at the back of the appliance) in the direction of the arrow.
Insert the battery as indicated. Put the battery cover back on
the battery compartment, and push it upward until you hear a
click.
4. USING THE ALLERGOLUX APPLIANCE
• Plug in the nasal applicator cable by inserting the jack in the socket on your
AllergoLux appliance.
• Spread the branches of the nasal applicator and insert the diodes deeply in the
nostrils.
The applicator should not cause any pain or discomfort.
• Turn the appliance ON to start AllergoLux. The green signal light on the
AllergoLux will stay lit for the entire session.
• After about 4 1/2 minutes, the green signal light turns off to show that the
session is over.
• Remove the diodes from the nostrils.
Comments:
• If the green signal light flashes, this means that the cable is not inserted
properly or that the battery is too weak for a full session.
• If the green signal light does not come on, and does not flash, the battery is
inserted incorrectly or is completely discharged.
5. DURATION AND FREQUENCY OF USE
• A treatment session using AllergoLux lasts only about 4 1/2 minutes. During
that time, the red light emitted by the diodes will have a wavelength of
approximately 660 nm at a given intensity. The automatic shutdown of the
system ensures that the cycle of use is always the same.
• Initially, we recommend using AllergoLux three times a day. Once the allergic
symptoms have decreased, you can reduce treatment to two sessions per day.
14
notice 1 14 2/05/06, 10:43