Care And Maintenance - Hilti SR 6-22 Manual De Instrucciones Original

3. Guide the saw through the workpiece.
▶ If you press the saw against the workpiece there is a risk of the saw blade breaking and causing
injuries.
Always use a saw blade of appropriate length. The saw blade must over the workpiece while the
complete Hubs stroke.
6.2 Guiding the saw
WARNING
Risk of injury by defective scaffold hook! A falling tool could injure you or others.
▶ Before starting work, check that the scaffold hook is secure and undamaged.
WARNING
Risk of injury due to saw run-on !
▶ Do not lift the product away from the workpiece until it has stopped completely.
▶ Wait until the product stops completely before you lay it down.
1. Disengage the transport lock and press the control switch.
▶ The graphics section illustrates various ways of guiding the saw effectively.
2. Release the control switch when you finish the cut.
3. Engage the transport lock.
6.3 Removing the saw blade
CAUTION
Risk of injury! The accessory tool may be hot and/or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
▶ Never lay down a hot accessory tool on a flammable surface.
1. Push the locking lever up as far as it will go and hold it in this position.
2. Pull the blade forward out of the blade holder.
3. Allow the locking lever to return to its original position.
7

Care and maintenance

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
• Carefully remove stubborn dirt.
• Carefully clean the air vents, if present, with a dry, soft brush.
• Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Clean and lubricate the blade holder from the outside at regular intervals. Use the Hilti spray #314648
•
for this purpose.
• Use a dry, clean cloth to clean the contacts of the product.
Care of the lithium­ion batteries
• Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
• Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
• Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
10 English
7
8
2243125
*2243125*