Publicidad
Idiomas disponibles
Idiomas disponibles
6.11.4 Sawing moldings
WARNING
Risk of injury due to incorrect securing of the workpiece. An incorrectly secured workpiece can skew
against the saw blade and lead to kickback.
▶ When you position the molding against the miter fence, take extra care to ensure that the molding is
adequately secured to prevent it moving out of position. → page 15
Moldings can be sawed in either of two ways:
•
set upright against the miter fence
•
Laid flat on the saw table
▶ Make the cut with or without push movement, depending on the width of the molding.
▶ First test the set miter angle and/or the bevel angle on an offcut.
7
Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care of the product
•
Carefully remove stubborn dirt.
•
Clean the air vents carefully using a dry, soft brush.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
•
Use a dry, clean cloth to clean the contacts of the product.
•
Clean the slider bars of the carriage and the extension supports at regular intervals. After each cleaning,
apply a few drops of oil to all slider bars.
•
Clean the contact surfaces of the top miter fences at regular intervals. Regrease the contact surfaces as
necessary.
Care of the Liion batteries
•
Never use a battery with clogged air vents. Clean the air vents carefully using a dry, soft brush.
•
Avoid unnecessary exposure of the battery to dust and dirt. Never expose the battery to high levels of
moisture (e.g. by being dipped in water or left in the rain).
If a battery has been soaked by moisture, treat it as a damaged battery. Isolate it in a non-flammable
container and consult Hilti Service.
•
Keep the battery free of extraneous oil and grease. Do not permit dust or dirt to accumulate unnecessarily
on the battery. Clean the battery with a dry, soft brush or a clean, dry cloth. Do not use cleaning agents
containing silicone as these can attack the plastic parts.
Do not touch the contacts of the battery and do not remove the factory-applied grease from the contacts.
•
Use only a slightly damp cloth to clean the housing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
Maintenance
•
Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
•
Do not use the product if signs of damage are found or if parts malfunction. Immediately have the product
repaired by Hilti Service.
•
After cleaning and maintenance, install all guards and protective devices and check that they are in full
working order.
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by Hilti for use with your product can be found at your
Hilti Store or online at: www.hilti.group
7.1
Cleaning the guard
1. Remove the saw blade. → page 13
2. Clean the parts of the guard carefully with a dry brush.
18
English
16
2395173
*2395173*
Publicidad
