Installation Of The Clima Control Eco; Operation Of The Clima Control Eco; Automatic Functions; Connecting Sensors Or Other Devices - TechGrow Clima Control Eco Manual

1. Installation of the Clima Control
Eco
1. Mount the TechGrow Clima Control Eco on the wall
with the supplied mounting kit, but not near a water
pipe or drain.
2. Mount the Temp Probe, preferably about one meter
above the floor.
3. Make sure the rocker switch is set to "OFF".
4. Plug the plug(s) of the fan(s) into the outlet(s) of the
Clima Control Eco.
5. Plug the Clima Control Eco into an electrical outlet.
6. Ready!

2. Operation of the Clima Control Eco

The Clima Control Eco controls the temperature in your
room. When the temperature exceeds "setpoint +
hysteresis", the fan speed will slowly increase until the
temperature drops below this value (setpoint +
hysteresis) again.
When the temperature falls below "setpoint -
hysteresis", the fan speed will slowly decrease until the
temperature rises above this value again.
In the event of a sensor failure, the fan speed increases
to the maximum speed ("MAX").

2.1 Automatic functions

Depending on the settings, the fans are automatically
controlled. After activation of the Clima Control Eco the
connected fans always start at full speed (for 1 second),
to guarantee that your fan starts no matter how low the
"BOX MIN" is. After setting the desired temperature, the
Clima Control Eco will
always maintain this temperature.
3. Connecting sensors or other
devices
The only sensor suitable for the Clima Control Eco is the
pre-assembled Temp Probe. It is not possible to connect
additional sensors or other equipment to the Clima
Control Eco.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions
4. Control and set the Clima Control
Eco

4.1 Set minimum fan speed

Turn the "TEMP" temperature knob all the way up to 45
°C. Set the rocker switch to "AUTO". The fan starts (the
fan must be switched on).
Now set the minimum fan speed to the desired level by
turning the "BOX MIN" knob.

4.2 Set maximum fan speed

Now, turn the "TEMP" temperature knob to 10 °C and
set the desired maximum fan speed by turning the "BOX
MAX" knob.

4.3 Temperature settings

Set the desired room temperature by turning the
"TEMP" knob.

4.4 Hysteresis

Set the hysteresis by turning the right rotary knob to the
desired value (1 °C - 7 °C).

4.5 Adjustment optimisation

Speeding up from the "BOX MIN" speed to the "BOX
MAX" speed and vice versa takes about 2 minutes. The
Clima Control Eco regulates less rapidly than other
controllers, creating a more stable climate. By playing
with the "BOX MIN" and the "BOX MAX" values you can
create the perfect adjustment. Do not set the "BOX MIN"
too low to prevent your fan from humming. This setting
can be different for each fan.

4.6 100% - full speed mode

The controller settings can be (temporarily) bypassed to
let the fan run non-stop at 100%, if desired. To do this,
set the rocker switch to the "100%" position.
To continue with the preferred temperature settings, set
the rocker switch back to "AUTO".

4.7 Switch off the Clima Control Eco

To switch off the Clima Control Eco and the operation of
the fans, set the rocker switch to "OFF".
9