Packaged Items; Operation; Layout For The Panel - Vector Welding ARC Serie Instrucciones De Operación

Operation

2.6 Packaged items

ARC 200G, ARC 200K
◆200 Amp electrode holder with 3M cable
◆300 Amp earth clamp with 3M cable
◆Operating Manual

3.1 Layout for the panel

1
2
3
5
31
ARC SERIES EQUIPMENT
4
6
ARC SERIES EQUIPMENT
4
5
WARNING
DO NOT TOUCH the electrode wire while it is being fed through the system. The electrode
wire will be at welding voltage potential.
1. Power indicator
The green power indicator will be illuminated when the welder is turned ON and indicates
the presence of power.
2.Thermal overload indicator light
This welding power source is protected by a self resetting thermostat. The indicator will
illuminate if the duty cycle of the power source has been exceeded. Should the thermal
overload indicator illuminate the output of the power source will be disabled. Once the
power source cools down this light will go OFF and the over temperature condition will
automatically reset. Note that the mains power switch should remain in the on position
such that the fan continues to operate thus allowing the unit to cool sufficiently. Do not
switch the unit off should a thermal overload condition be present.
3. Digital Ammeter (ARC 200G Without this feature)
The digital Ammeter is used to display the actual output current of the power source.
Operation
1
2
6
32