Led Replacement - EXPO Quadro Vino QV52 Manual De Mantenimiento

E. LED REPLACEMENT
E1 . Disconnect the LED cables
unscrewing the terminals
F. REPLACEMENT OF THE THERMOELECTRIC SYSTEM QV52
F1 . Unscrew the screws inside the
metal bottle casing
G. REPLACEMENT OF THE THERMOELECTRIC BOARD
G1. Unscrew the nuts an extract
the spacers and the electronic
board
On the website www.exposrl.com the following documents can be downloaded:
Document
Exploded view
Wiring diagram
User instruction manual
All manuals and user guides at all-guides.com
(operation time 10 min)
E2 . Loosen the screws that fix the
LED bar to the metal casing
F2 . Remove the bottle casing and
disconnect the thermoelectric
system
G2. Disconnect and reconnect
cables in the same position (see
wiring diagram)
Browser link
www.exposrl.com >> technical area >> parts and exploded
www.exposrl.com >> technical area >> wiring diagrams
www.exposrl.com >> technical area>> user instructions
E3 . Remove the defective LED bar
F3 . Unscrew the two bolts that secure
the thermoelectric device to the
casing and remove it
(OPERATION TIME AROUND 10 MIN)
G3. Insert the new board into the
casing with its rubber spacers
ENGLISH
E4 . Insert the new LED bar
repositioning each bulb in its
hole in the casing, screw back
and reconnect.
(OPERATION TIME AROUND 15 MIN)
F4 . Insert the new thermoelectric
system, screw the bolts and
connect it
G4. Tighten the nuts until the
buttons can be operated from
the outer trim
File name
QV52 ( EV )
QV52 ( SE )
QV52 ( MI )