Troubleshooting - GUTFELS CLEAN3010 Manual De Instrucciones

EN

16 Troubleshooting

Fault
The vacuum cleaner
does not work.
If the vacuum cleaner
has no suction power.
If the vacuum cleaner
does not work as it
should or if there are
noises and/or whistling
sounds.
If the cable does not
wind up completely.
Page | 30
Possible cause
The appliance is not switched
on
The electrical plug is faulty
The appliance is not plugged
into the plug socket
An accessory: Hose or pipe,
nozzles or brushes are blocked
The HEPA filter is soaked/dirty
An accessory: Hose or pipe,
nozzles or brushes are blocked
The dust container is full
The cover of the container is
not positioned correctly
The dust container is not
positioned correctly
The manual air flow regulator
is open
The cable winds up slowly
Remedy
Switch on the appliance.
Contact a qualified
technician.
Plug the appliance into the
plug socket.
Remove what is causing the
blockage.
Clean the filter.
Remove what is causing the
blockage.
Empty and clean the dust
container.
Close the cover properly.
Position the dust container
correctly.
Close the manual air flow
regulator.
Unwind the cable and press
the button again. If in
doubt, consult a qualified
expert.