Cosatto ME-MO Instrucciones página 5

6 - fastening harness buckle
Fit the two shoulder strap buckle parts together and push into the crotch fitting until a firm click
is heard. To open press the RED button.
7 - changing the handle position
The handle can be placed in 3 different positions:
1. Fitted in the car position
2. Carrying position
3. Stow position
4. Steady position
To change positions, push the button (a) on both sides of the handle and move the handle
rearward or forward.
8 - fitting the hood
Fit the hood by fastening the poppers on either side of the seat and then pull the back of the hood
behind the seat.
9 - removing the seat cover
Loosen the TMS system (See step 5).
Remove the straps from the distribution plate in the compartment behind the seat (a) and then
pull the straps from the seat (b).
Remove the buckle located at the front of the seat (c) and then remove the liner (d).
Remove the seat cover from the seat (e).
Re-fitting the cover is a reversal of this procedure.
NOTE: Never remove the polystyrene block from the child car seat.
10 - attaching the child car seat to the chassis
First attach the seat adaptors into the housings on the chassis (These are supplied with the car
seat) The arrows on the adaptors and housings should align. Attach the child car seat to the
adaptors to fix in place The red spot on the child car seat should align with the arrows. Ensure the
seat is fully engaged on the chassis before use. To remove the child car seat from the chassis press
the release buttons on both adaptors (a).
Note: The child car seat can only be used rearward facing. Please also ensure the adaptors are
correctly fitted as shown.
Note: Do not remove the adaptors with the child car seat. Remove these separately by pressing
the release buttons on both adaptors (b) when not required.