Fold Test; Before Initial Use - Sunbeam 112866 Manual Del Usuario

Fold test

All manuals and user guides at all-guides.com

Before initial use:

1 Remove product from vinyl storage bag /box.
2 Pull controls from center fold of the warming product.
3 Make sure the control cord (base unit cord – remote
only) is connected to the mattress pad module then plug
the power cord into an outlet.
4 Press "On/Off" button, then turn the control to the
highest setting and wait five to seven minutes.
5 Put your hand between the folds and you should feel the
mattress pad warming. Note: Remember, the warming
product is not a heating pad. It will not feel hot to the
touch when laid out flat in a normal manner.
CAUTION: Do not continue the fold test for more than seven minutes. DO NOT
attempt to make any internal adjustments to this appliance. If you have followed
each step of the fold test and the warming product does not heat, stop using it
immediately, disconnect the power cord and contact Consumer Services at the
800 number listed under How to Obtain Warranty Service (page 14).
3