Mounting Instructions; Setting The Time - Roadstar CLR-2540UMP Manual De Instrucciones

3 English
16. STOP BUTTON
17. TIME SET BUTTON
18. SNOOZE BUTTON
19. SLEEP BUTTON
20. OPEN/CLOSE BUTTON
Note: Please pull battery protector before using.
To operate the unit with the remote control, point the remote handset at the
remote sensor on the front panel and press the appropriate button on the re-
mote handset. The remote works best within a range of 6 ~ 7 meters from the
front panel and on an angle of 30 degrees. Bright sunlight or room light condi-
tions can interfere with the remote control. If the remote operation is unsati-
sfactory or stops working entirely, first try replacing the remote batteries, then
try reducing the room lighting conditions.

MOUNTING INSTRUCTIONS

1. Drill 3 x 6,5mm diameter holes through the underside of the cabinet bot-
tom shelf using the three points marked on the template.
2. Select the spacer or combination of spacers that fit your preferences,
from the mounting kit.
3. Fix the unit using the screws from the mounting kit.
MAINS (AC) OPERATION
Before switching on make sure that the voltage of your electricity supply is
the same as that indicated on the rating plate.
For your own safety read the following instructions carefully before attempting
to connect this unit to the mains.
This unit is designed to operate on AC 230V 50Hz / DC 6V current only. Con-
necting it to other power sources may damage the unit.
To prevent electric shock disconnect from the mains before removing cover.
No user serviceable parts inside. Refer servicing to qualified service person-
nel.

SETTING THE TIME

Note: Please make sure that all connections have been ready.
1. In standby mode, press and hold the PROG BUTTON (10) button, the
Hour digits will flash. Press SKIP BACK/TUNING- BUTTON (12)/SKIP
UP/TUNING+ BUTTON (14) on unit or (4)/(14) on remote repeatedly to
set the clock to the correct Hour, press the PROG BUTTON (10) button to
confirm.
2. Then the minute digits will flash, press SKIP BACK/TUNING- BUTTON
All manuals and user guides at all-guides.com