Napa 85-640 Manual De Instrucciones página 9

All manuals and user guides at all-guides.com
When disconnecting the charger, turn the switch to OFF (O), disconnect
the AC cord, remove the clamp from the vehicle chassis, and then remove
the clamp from the battery terminal.
CAUTION: WHEN THE POSITIVE (+) POST OF THE VEHICLE
BATTERY IS GROUNDED, DOUBLE-CHECK POLARITY.
8. CHARGING BATTERY OUTSIDE VEHICLE OR EqUIPMENT–NOT
CONNECTED TO ENGINE
If necessary to remove the battery from the vehicle or equipment, always
remove the grounded terminal from the battery first.
WARNING: MAKE SURE ALL VEHICLE LOADS ARE OFF TO
PREVENT A POSSIBLE ARC.
FOLLOW THESE STEPS WHEN THE BATTERY IS OUTSIDE THE
VEHICLE. A SPARK NEAR BATTERY MAY CAUSE AN EXPLOSION.
TO REDUCE RISK:
8. Check the polarity of the battery posts. The POSITIVE (POS., P, +) post
usually has a larger diameter than the NEGATIVE (NEG., N, –) post.
8.2 Attach an insulated battery cable that is at least a 24-inch, 6-gauge to the
NEGATIVE (NEG., N, –) battery post.
Connect the POSITIVE (RED) charger clamp to the POSITIVE (POS., P,
8.3
+) post of the battery.
8.4 Position yourself and the free end of cable as far away from the battery as
possible. Do not face the battery when making the final connection. Then
connect the NEGATIVE (BLACK) charger clamp to the free end of the cable.
8.5 When disconnecting the charger, always do so in the reverse sequence of
the connecting procedure. Break the first connection while staying as far
away from the battery as practical.
8.6. A marine (boat) battery must be removed and charged on shore. To
charge it on board requires equipment specially designed for marine use.
7
• •