Uline H-6920 Manual Del Usuario página 2

2. With crossbrace on its side, push legs through the
casting collars to the desired height. To ensure exact
height, mark desired height on each leg with magic
marker or grease pencil. (See Figure 3)
Figure 3
NOTE: Each leg must be at the same height or
casting collars could fail. Recommended height
from the floor to the top of the crossbracing is 10"
and must be 6" or higher to meet NSF standards.
NOTE: Optional casters add 3⁄" to height.
3. Secure legs to crossbrace with set screws using 5/32"
Allen wrench. (See Figure 4)
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
4. Stand table upright and place tabletop onto legs,
inserting legs into the tabletop gussets. With a 5/32"
Allen wrench, tighten set screws on each gusset.
(See Figure 5)
Figure 5
5. Level table with the adjustable feet. Adjustable feet
allow approximately 1" of adjustment. (See Figure 6)
Figure 6
0122 IH-6919