Uline H-6979 Manual Del Usuario

H-6979, H-6980, H-6981
π
H-6982, H-9268
MACHINE TABLE
TOOLS NEEDED
13 mm Wrench
Top Panel x 1
1. Place top panel on a smooth, non-marring surface
with top side facing down.
2. Attach legs to outside of top panel using four bolts
and four flange nuts on each leg. (See Figure 1)
NOTE: Do not tighten all the way.
Figure 1
Bolt
3. Determine desired overall height and lower shelf
location.
4. Place lower shelf inside of legs and attach using
four bolts and four flange nuts on each leg. Do not
tighten. (See Figure 2)
Flange
Nut
Bolt
Figure 2
PAGE 1 OF 3
1-800-295-5510
uline.com
14 mm Wrench
PARTS
Lower Shelf x 1
Leg x 4
ASSEMBLY
Flange
Nut
Adjustable Foot x 4
5. Place feet at desired height on outside of legs and
attach using four bolts and four flange nuts on each
foot. Tighten all bolts. (See Figure 3)
Bolt
Figure 3
NOTE: If foot and shelf overlap, unscrew one
side at a time and replace.
NOTE: Leave at least one open hole between
bolt locations.
6. Set machine table upright and check all bolts and
nuts for tightness. (See Figure 4)
Figure 4
NOTE: If table is not level, loosen and retighten
bolts as needed.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Flange Nut x 48
Bolt x 48
Flange
Nut
1120 IH-6979