Thermador T24UW925LS Guia De Instalacion página 19

3. Remove the door gasket from the corners, by pulling it gently until the four screws are visible.
Then remove the two screws further to the corner. The two holes shown on the below illustration
must be accessible to screw (install) the custom overlay frame to the door. There should be 8
accessible holes in total, two per corner.
NOTE: It is not necessary to remove the entire gasket from the door, just from the corner, enough
to access to the screws.
4. Align the overlay frame with the door and hold them firmly together while screwing them. It may
be easier with the help of another person to hold and keep the frame in place while fastening.
Using the 8 screws included in the installation kit, fasten the overlay frame to the door.
Align door and frame
Remove the
screws to
leave these
holes
Fasten together
Page | 19