Schumacher Electric SI-200A Manual Para El Propietario página 45

All manuals and user guides at all-guides.com
50 Amp Battery Clips
1. Connect the end of the charger output cable to the end of the 50 Amp
Battery Clips cable.
2. Follow the steps in sections 6 and 7 to connect the output clips to the
battery.
3. After a good electrical connection is made to the battery, plug the power
cord into an AC electrical wall outlet. (See the warning label on the charger
for the correct input voltage.) Make sure to place the charger on a dry, non-
flammable surface like metal or concrete.
Permanent Ring Connectors
The ring connectors permanently attach to the battery providing easy access
to quickly charge your battery. This application is appropriate for motorcycles,
lawn tractors, ATVs and snowmobiles.
1. To permanently attach it to a battery, loosen and remove each nut from the
bolts at the battery terminals.
2. Connect the red positive connector ring to the positive (POS, P, +) battery
terminal.
3. Connect the negative connector ring to the negative (NEG, N, -) battery
terminal.
4. Replace and tighten the nuts to secure them.
5. Connect the ring connector cable assembly to the charger. Take care to
keep both wires and plug away from hot and moving parts.
6. Plug the charger power cord into an AC electrical wall outlet. (See the
warning label on the charger for the correct input voltage.) Make sure to
place the charger on a dry, non-flammable surface like metal or concrete.
12V Accessory Plug
Charge or maintain your battery without lifting the hood.
1.
Connect the end of the charger output cable to the end of the 12V
accessory plug cable.
2. Insert the 12V accessory plug into the 12V accessory outlet.
3. Route the power cord from the charger through the vehicles open window.
4. Plug the power cord into an AC electrical wall outlet. (See the warning
label on the charger for the correct input voltage.) Make sure to place the
charger on a dry, non-flammable surface like metal or concrete.
Battery Connection Indicator
If the charger does not detect a properly connected battery, the CHECK
BATTERY LED will light. Charging will not begin if the CHECK BATTERY LED
is on.
Automatic Charging Mode
When an Automatic Charge is performed, the charger switches to the Maintain
Mode (see below) automatically after the battery is charged. For a battery with
a starting voltage under 1 volt, use a manual charger to pre-charge the battery
for five minutes to get additional voltage into the battery.
Aborted Charge
If charging cannot be completed normally, charging will abort. When charging
aborts, the charger's output is shut off and the CHECK BATTERY LED will
blink. In that state, the charger ignores all buttons. To reset after an aborted
charge, unplug the charger from the AC outlet, wait a few moments and plug it
back in.
40
• •