How To Use - Inateck FD2102 Manual De Instrucciones

All manuals and user guides at all-guides.com

How to Use

1. Connect the external power adapter from the hard drive dock to an
electrical outlet.
2. Connect the included USB 3.0 cable from the hard drive dock to an
available USB port on the computer system.
3. Insert a 2.5" or 3.5" hard drive into the top loading slot.
4. Press the power button. A pop-up bubble in the task bar at the bottom-
right of your screen notifying you once your hard drive has been
recognized. You may also find the hard drive in Disk Management.
Note:
a. To remove the hard drive, make sure it is currently not being accessed
by the computer then unmount or uninstall the disk drive from the
operating system. Never remove the docking station while the hard
drive is in use. Doing so may corrupt the data on the hard drive or
damage the hard drive, docking station, or computer.
b. When connected via USB, the dock will automatically go into sleep
mode if the connection is left idle for more than 30 minutes. The
power LED indicator will flash every 3 seconds. Accessing the hard
drive will automatically cancel sleep mode and power the drive back
up. The hard drive LED indicator will flash and the power LED indicator
will be constantly on.
c. Please do not remove your hard drive or insert a new one while
the other hard drive is being accessed, as doing so the other drive
temporarily disconnects and this could damage your hard drive and
result in data loss.
Hard Drive Offline clone
1. Make sure there are no connection on the USB.
2. Insert the drives straight down until the connection is secured. Offline
clone is from HDD A to HDD B. Make sure your Main Drive is in HDD
A and slave in HDD B. The capacity of HDD B must be equal or bigger
than HDD A.
3. Press and hold the offline clone button for 3 seconds, the 100%
indicator will light up. Then quickly press the offline clone button
again and the offline clone operation will start. Each LED represents
25% completion. It is only when every 25% of HDD A is offline clone
to HDD B that such LED will remain constantly on. When offline clone
operation is fully completed, all LEDs will constant on until the device
is power off.
LED
2