Ipod Operations; Playing An Ipod; Setting The Play Mode - Sony XAV-62BT Manual De Instrucciones

iPod Operations

For details on the compatibility of your iPod, see
"About iPod" on page 62 or visit the support site.
Support site
http://esupport.sony.com
http://www.sony.com/mobileAV
In these Operating Instructions, "iPod" is used as
a general reference for the iPod functions on the
iPod and iPhone, unless otherwise specified by
the text or illustrations.

Playing an iPod

1
Reduce the volume on this unit.
2
Remove the cap from the USB
connector, and connect the iPod to the
USB connector.
Use of the optional USB connection cable
RC-202IPV is recommended.*
While the iPod is connected, a device
connected to the front AUX terminal becomes
unavailable, and "Front AUX" cannot be
selected when changing the source.
The following display appears on the iPod
screen* 2 , then playback starts from the item
last played.
If an iPod is already connected, to start
playback, touch "Source List," then "iPod/
USB."
*1 To play videos from an iPod with video, use of
the RC-202IPV is required.
*2 May not appear in the case of an iPod touch or
iPhone being connected, or when the iPod was
last played using passenger control.
3
Adjust the volume on this unit.
About playback controls and
indications
You can control iPod playback in the same way
as disc playback. For details, see "Playback
controls" on page 18.
For details on playback indications, see
"Playback indications" on page 19.
To stop playback
Press and hold (SOURCE/OFF) for 1 second.
To disconnect the iPod
Stop playback, then disconnect.
Do not disconnect during playback, as data in the
iPod may be damaged.
About resuming mode
When the iPod currently playing is connected to
the dock connector, the mode of this unit changes
to resuming mode and playback starts in the
mode set by the iPod.
In resuming mode, repeat/shuffle play are not
1
available.
Caution for iPhone
When you connect an iPhone via USB, telephone
volume is controlled by the iPhone itself. In order to
avoid emitting sudden loud sound after a call, do not
increase the volume on the unit during a call.
Note
This unit cannot recognize an iPod via a USB hub.
Tips
• When the ignition key is turned to the ACC position
with the unit on, the iPod will be recharged.
• If the iPod is disconnected during playback, "USB
device is not connected." appears on the display of
the unit.

Setting the play mode

You can set one of the following play modes.
For audio playback
"ALBUM," "TRACK," "GENRE,"
"PLAYLIST," "ARTIST," "MUSIC
PODCAST"*
For video playback
"MOVIE," "RENTAL," "TV SHOW," "MUSIC
VIDEO," "VIDEO PLAYLIST," "VIDEO
PODCAST"*
* May not appear depending on iPod setting.
1
During playback, touch "List."
2
Touch "MUSIC" or "VIDEO."
continue to next page t
29